A replica Pasha black is a copy of the Cartier Pasha watch built with a black dial, a black bezel, or a black coated case. Most versions sold online pair a 41mm steel case with a quartz or automatic movement and sell for a small share of the original price. This guide covers the variants you will see, the movements inside them, the materials used, and the checks that separate a good copy from a bad one.
What Makes the Pasha Black Design Distinct?
Cartier launched the modern Pasha in 1985, reviving a design first drawn for the Pasha of Marrakesh in the 1930s. The watch keeps a round case, a screw-down crown cap on a small chain, Vendôme lugs, and bold Arabic numerals. Black versions take that frame and swap the dial, the coating, or the strap for a darker look.
Which Pasha Black Variants Do Sellers Offer?
The copy market follows the original catalog, so the black versions you find online map to real Pasha references.
Pasha de Cartier 41mm Black Dial
This is the most common copy. It uses a 41mm steel case, a black sunburst or matte dial, white printed numerals, and a black leather or rubber strap.
Pasha Seatimer Black
The Seatimer adds a rotating bezel, a screw-down crown without the chain cap, and a rubber strap built for water sports. Copies of this model show up with black ceramic or PVD bezels.
Pasha C and Smaller Sizes
Pasha C copies run 35mm to 38mm and suit slimmer wrists. Black dial versions of these are common in quartz, and many use a steel bracelet instead of leather.
Quartz or Automatic: What Is Inside a Replica Pasha Black?
Most black Pasha copies run on a quartz module, which keeps time well and needs a battery swap every two to three years. Higher priced copies use an automatic movement with a date window and a sweeping seconds hand. Automatic versions cost more, weigh more, and need service if they stop.
- Quartz: light, accurate, low cost, no winding.
- Automatic: sweeping hand, more weight, higher price, service needed over time.
Materials: What to Look For in the Case, Crystal, and Strap
Case material drives both the price and how the watch ages. Steel cases hold up, while brass cases with chrome plating wear through at the lugs after months of daily use.
- Crystal: sapphire resists scratches. Mineral glass scratches and looks dull after a year.
- Black finish: PVD and DLC coatings outlast paint. Deep scratches on DLC show the steel underneath.
- Strap: real leather, rubber, or a steel bracelet. Bonded leather cracks at the spring bar within months.
- Case back: a screw-down back with a gasket seals better than a snap-on back.
How Do You Check a Replica Pasha Black Before Buying?
- Ask for photos of the crown cap. On the Pasha, the cap unscrews and reveals the crown. A cap that does not turn is glued shut.
- Check the dial print. Numerals should sit level, with even spacing and no blur at the edges.
- Confirm the movement in writing. Sellers who list quartz and ship a dead automatic are common.
- Check lug width. 20mm and 21mm are standard, so straps are easy to replace.
- Ask about water resistance. A rating of 30m means splash resistance, not swimming.
- Read the return policy. A 14 day return window matters more than a low price.
What Does a Replica Pasha Black Cost?
Prices track the movement and the crystal, not the name on the dial. Most listings land between about $50 and $350. Shipping, customs, and payment fees can add to the listed price, so compare the total before you order.
- Entry tier (under $100): quartz, mineral glass, plated case, leather strap.
- Mid tier ($100 to $200): quartz or basic automatic, sapphire option, steel case.
- Top tier (over $200): automatic, sapphire crystal, steel bracelet, better finishing on the crown cap.
How Does a 41mm Pasha Fit on the Wrist?
A 41mm Pasha wears large because the crown cap adds width on the right side. A 35mm to 38mm copy fits a wrist under 6.5 inches with room to spare. Measure your wrist before you order and check the strap length, since many sellers ship a standard 115mm to 75mm strap that runs short on bigger wrists.
Care Tips for a Black Finished Pasha Copy
- Wipe a PVD or DLC case with a soft cloth. Abrasive polish strips the coating.
- Rinse the case with fresh water after contact with salt water or sunscreen.
- Replace the battery on a quartz model before it leaks, or the movement corrodes.
- Store the watch away from speakers and phone magnets, which pull an automatic movement off rate.
- Replace gaskets when a watchmaker opens the case, since old rubber lets moisture in.
FAQ About Replica Pasha Black Watches
Will a replica Pasha black pass as the real thing?
From arm's length, a good copy reads as a Pasha. Under a loupe, dial print, crown cap threading, and case back engraving give it away. Buyers who care about resale or service history should skip copies.
Is a black PVD finish durable?
PVD holds up against scratches better than paint but not as well as DLC. Rub points like the case back edge, lugs, and clasp show wear first.
Can I swim with it?
Only if the listing states 100m or more and the case back has a gasket. Crown caps on copies often lack a proper seal, so treat any unrated watch as splash proof.
What is the difference between a replica and a homage?
A replica copies the brand name and logo. A homage keeps the shape and drops the branding. Homages cost less and carry no trademark risk on the dial.
Legal Notes Before You Buy
Cartier owns the Pasha trademark, and US customs can seize shipments of goods that carry a counterfeit mark. Rules differ by country, so check your local import law. This page explains the market; it does not sell or endorse counterfeit goods.