Short answer
A fake IW328070 is a copy of an IWC Pilot's Watch. Most copies fail one of three checks: caseback engraving, dial print, or movement finish. Run all three before you pay. A $300 copy and a $6,000 IWC look alike at arm's length. They do not look alike under a 10x loupe.
What the number means
IWC reference numbers pack family, case metal, dial color and strap code into six digits. IW328070 opens with 3280 and closes with a two-digit variant code. Confirm the exact code on IWC's own listing. Spec sheets for one variant do not transfer to another.
Write down these figures for the exact variant you are checking:
Fake IW328070 Buying Guide: How to Choose an IWC Pilot Replica
- Case diameter and thickness in millimeters
- Lug width
- Water resistance in bar
- Caliber number and power reserve in hours
- Crystal type and coating
- Strap or bracelet reference
Check 1: case and caseback
Measure the case with calipers. The Mark XX case measures 40.0 mm across with 20 mm lugs. Copies run 0.3 mm to 0.8 mm wide or narrow.
Fake IW328070 Compared to Genuine: Which Replica Tier Wins?
Turn the watch over. IWC cuts the reference, the serial and the water resistance into the steel. The cuts are sharp and even. Replica engraving looks shallow and rounded, or laser-etched and gray.
- Serial format: six or seven digits, separate from the reference
- Font: reference digits sit level, with even spacing
- Finishing: brushing runs one direction on the lugs, polish on the bezel edge stays crisp
Check 2: dial and hands
Use a 10x loupe. Real dial print sits flat with hard edges. Replica print sits thick, and letters bleed at the corners.
- Applied markers: all twelve indexes sit at the same height and line up with the minute track
- Date wheel: the numeral sits centered in the window, with the same font weight as the printing
- Lume: IWC uses a cream tone on the Pilot's line. Cheap copies use a pale green that reads bright under indoor light
- Hands: the minute hand reaches the minute track, no more, no less
Check 3: movement
IWC fits the caliber 32111 to the Mark XX. It carries a 120-hour power reserve. Copies use a Miyota 9015, a Seiko NH35 or a Chinese clone. Each runs at a different beat rate.
Put the watch on a timegrapher. Note the rate in seconds per day and the amplitude. A healthy 32111 holds a steady rate across positions. A clone drifts 10 to 20 seconds between dial up and crown down.
Look at the rotor. Real IWC rotors carry engraved text with clean edges and a brushed finish. Replica rotors use printed text that flakes.
Paperwork and price
A new Mark XX sells for about $6,000 on a strap and about $6,600 on a bracelet. Ask for the IWC warranty card and the dealer stamp. IWC registers watches to the owner online, so a card alone proves little.
Replica sellers ask $250 to $700. Below $200 expect a quartz movement or a printed dial.
What copies get right
Good replicas match the case profile, the dial layout and the sapphire crystal. Lume, engraving depth and movement finish stay the weak points. Buy from a seller who shows macro photos of the caseback and the movement.
Buying checklist
- Get the exact reference in writing.
- Ask for a caliper photo of the case.
- Ask for a macro shot of the caseback.
- Ask for a timegrapher photo.
- Ask for a movement photo with the rotor visible.
- Compare each photo to IWC's product images.
Bottom line
Three tools settle most fakes: calipers, a loupe and a timegrapher. Numbers beat opinions. If the seller cannot send photos of the caseback and the movement, walk away.